High performance Quadflex maintenance free AGM Motobatt 12 volt 19Ah battery. Quadflex technology means you have two positive and two negative threaded terminals allowing maximum flexibility when installing. Motobatt absorbed gel matting batteries feature the latest absorbent glass mat technology. This offers increased lifespan, higher vibration resistance and electrical performance. This battery is also leak, vibration and spill proof if installed correctly
Suitable as a replacement for Guzzi ref. 03704571. If fitted to CARC models the top battery securing bracket will need to be omitted or modified as this battery has a different profile to the OE Yuasa battery.

Supplied charged and ready to fit, Motobatt Quadflex batteries produce 20% more cranking power (250 CCA) and are spill proof. This battery is physically smaller than the original battery fitted to some V35, V50 and V65 models, it may require packing out in the battery compartment.
NB This battery must not be trickle charged or charged using a traditional manual charger, AGM batteries require a smart charger - we recommend ACA96000
For more information on charging AGM batteries see these FAQ's.
Can also be used to replace Odyssey PC925L where a bike is in regular use (this battery should be installed on its side).

One year warranty on all our Motobatt batteries

Also available at the same price in black by special order - call 01484 841395 to order

Please note this part CANNOT be posted outside of the UK mainland area

 Availability varies on this part, check availability

 883818 MG883818

Neutral switch

Also known as Guzzi ref. 19207200

 This part is due back in stock soon, call 01484 841395 to reserve yours

 19207220 GU19207220 19 20 72 20
 1920 7220 1920.7220 19.20.72.20

Reconditioned Valeo starter motor and solenoid in black and silver finish. Professionally reconditioned and sold with a 12 month guarantee. This is a suitable replacement for Bosch 8 or 9 tooth Guzzi starter motors. Minor modification may be required on some pre 1990 models to make room for the solenoid. Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology. See , see this link for the modifications required to fit a Valeo starter to a 4 speed model.

This is an exchange only item, we can supply these before receiving your exchange unit subject to a refundable deposit so you can keep your bike on the road. See ELC10737 for the refundable deposit. Send your old starter motor to our registered address. NB In case of starter motor problems do not tap the casing as this will certainly cause it to fail. See SSA08075 for mounting bolts. Also known as Guzzi ref. 30730710
Do not remove second nut from terminal posts when fitting - this nut is required to hold the terminal in place

Supercedes Guzzi refs. 12730705, 14730554 and 14730705

 30730711 GU30730711 30 73 07 11
 3073 0711 3073.0711 30.73.07.11

NGK C8HSA Spark plug

 This part is due back in stock soon, call 01484 841395 to reserve yours

27717021-z 27717021 GU27717021 27 71 70 21
 2771 7021 2771.7021 27.71.70.21

Pair low and high chrome Voxbell horns. Rear of horn is black, two connection terminals on one horn, four on the other

 This part is due back in stock soon, call 01484 841395 to reserve yours

 14743700 GU14743700 14 74 37 00
 1474 3700 1474.3700 14.74.37.00

Also fits Laverda

Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with standard 3 Ohm 12 volt coils and can be used to replace points or Motoplat ignition on models with Saprisa charging systems. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Eliminates vague timing due to worn distributors on big twins. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. Once fitted no further adjustment should be necessary. See this link for fitting instructions. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA31165

 This part is available by special order, request a quote

Complete round 203mm left hand dip (UK spec) headlight unit with bulb. Black body with chrome rim.

Due to the scarcity of LH dip Italian made headlights we have sourced this reasonably priced alternative which is similar in size to the headlamp used on V50 and T3 models. Supplied complete with headlight bulb. Headlamp is slightly larger than stock so some repositioning of the headlamp brackets may be required. Please note there is no pilot light with this headlamp and thread size for bolt fixing holes is M8. This is a smaller thread than the M10 thread on T3 indicator stems.

 This part is available by special order, request a quote

Complete round black headlight with chrome rim, complete with bulb and pilot light. Right hand dip non-UK spec.

This light will fit Le Mans Fairing FAA99575

 This part is available by special order, request a quote

Brand new genuine Valeo starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016
Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.

This is a genuine Valeo starter made in the EU- please do not confuse with the cheap Chinese copies that sometimes appear on eBay.

Supercedes Guzzi refs. 12730705, 14730554 and 14730705

Please note you can get a discount of £30 on this item if you part exchange your existing faulty starter motor. See ELA30837 for less expensive alternative part

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30730711 GU30730711 30 73 07 11
 3073 0711 3073.0711 30.73.07.11

Brand new right hand original "Lego" type switchgear and twistgrip with switches for starter and run/kill.
Previously unavailable new and ideal for your restoration project.

Comes with attached 4 pin molex connector, molex pins and rubber boot, ready to be plugged into your standard loom. Twistgrip for standard dual throttle cables.

See ELA17061 and ELA14055 for left hand switches.

 Sorry, this part is no longer available.